Differences

This shows you the differences between two versions of the page.

--- userdoc:guest_vm_hyperv [2017/03/28 17:33]
abelbeck
+++ userdoc:guest_vm_hyperv [2017/03/28 17:51]
abelbeck
@@ Line 29: / Line 29: @@
 !!Special Thanks ->!! Nick Mace graciously provided the following configuration detail.
-... TBD ...
+Create a new virtual machine using Hyper-V Manager. If using Hyper-V Server 2012R2 or later, you must select a "Generation 1" virtual machine. The screenshot below shows a new virtual machine with the default configuration and a virtual hard disk attached:
+{{:userdoc:vm_hyperv-1-NewVirtualMachine.png?nolink|1-NewVirtualMachine}}
+{{:userdoc:vm_hyperv-2-AddNetworkAdapter.png?nolink|2-AddNetworkAdapter}}
+{{:userdoc:vm_hyperv-3-ConfigureOtherNetworkAdapters.png?nolink|3-ConfigureOtherNetworkAdapters}}
+{{:userdoc:vm_hyperv-4-MountISO.png?nolink|4-MountISO}}
+{{:userdoc:vm_hyperv-5-SetRequiredNumberofProcessors.png?nolink|5-SetRequiredNumberofProcessors}}
+{{:userdoc:vm_hyperv-6-SetRequiredMemory.png?nolink|6-SetRequiredMemory}}
+{{:userdoc:vm_hyperv-7-InstallAstLinux.png?nolink|7-InstallAstLinux}}
+{{:userdoc:vm_hyperv-8-EjectISO.png?nolink|8-EjectISO}}
+{{:userdoc:vm_hyperv-9-AstLinuxRunning.png?nolink|9-AstLinuxRunning}}
 Finally, configure AstLinux using the normal **[[userdoc:new-install|setup]]**.
 !!Tip ->!! Note the "IPv4 Address:" on the screen and access the VM with SSH or an HTTPS browser on the same network.