Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:guest_vm_hyperv [2017/03/24 12:02] droemel |
userdoc:guest_vm_hyperv [2017/03/28 17:33] abelbeck |
||
---|---|---|---|
Line 5: | Line 5: | ||
**VM Host Specifications: | **VM Host Specifications: | ||
- | **VM Host Requirements: | + | **VM Host Requirements: |
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 16: | Line 16: | ||
* CPU: 2 Processor Cores | * CPU: 2 Processor Cores | ||
* Virtual Storage: 4 to 8 GB | * Virtual Storage: 4 to 8 GB | ||
- | * Network: Virtual Switch (needs to be created | + | * Network: Virtual Switch (needs to be created |
- | * !!Info:!! The Legacy Network Adapter uses the " | + | |
+ | **Assumptions:** | ||
+ | |||
+ | * A working installation of Hyper-V Server. These instructions use Hyper-V Server 2012R2. | ||
+ | * A Virtual Switch configured within Hyper-V Server. | ||
+ | * Hyper-V Manager available, | ||
+ | * AstLinux installation ISO copied to local storage on the server. | ||
**Configuration: | **Configuration: | ||
+ | |||
+ | !!Special Thanks ->!! Nick Mace graciously provided the following configuration detail. | ||
... TBD ... | ... TBD ... | ||
Line 26: | Line 34: | ||
!!Tip ->!! Note the "IPv4 Address:" | !!Tip ->!! Note the "IPv4 Address:" | ||
- | |||
- | After persistent storage is configured, edit the ''/ | ||
- | |||
- | ## These modules get modprobe' | ||
- | rtc | ||
- | ## Comment out any modules you don't need. | ||
- | ## | ||
- | ## Ethernet support | ||
- | ## Virtual first, then Emulated | ||
- | ## | ||
- | hv_netvsc | ||
- | virtio-pci | ||
- | vmxnet3 | ||
- | pcnet32 | ||
- | e1000 | ||
- | e1000e | ||
- | 8139too | ||
- | |||
- | Correspondingly, |