Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:guest_vm_hyperv [2017/03/24 09:23] droemel |
userdoc:guest_vm_hyperv [2017/03/28 17:51] abelbeck |
||
---|---|---|---|
Line 4: | Line 4: | ||
**VM Host Specifications: | **VM Host Specifications: | ||
+ | |||
+ | **VM Host Requirements: | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 14: | Line 16: | ||
* CPU: 2 Processor Cores | * CPU: 2 Processor Cores | ||
* Virtual Storage: 4 to 8 GB | * Virtual Storage: 4 to 8 GB | ||
- | * Network: Virtual Switch (needs to be created | + | * Network: Virtual Switch (needs to be created |
- | * The Legacy Network Adapter uses the " | + | |
+ | **Assumptions: | ||
+ | |||
+ | * A working installation of Hyper-V Server. These instructions use Hyper-V Server 2012R2. | ||
+ | * A Virtual Switch configured within Hyper-V Server. | ||
+ | * Hyper-V Manager available, | ||
+ | * AstLinux installation ISO copied to local storage on the server. | ||
**Configuration: | **Configuration: | ||
- | ... TBD ... | + | !!Special Thanks ->!! Nick Mace graciously provided the following configuration detail. |
- | Finally, configure AstLinux using the normal **[[userdoc: | + | Create a new virtual machine using Hyper-V Manager. If using Hyper-V Server 2012R2 or later, you must select a " |
- | !!Tip ->!! Note the "IPv4 Address:" on the screen and access the VM with SSH or an HTTPS browser on the same network. | + | {{:userdoc: |
- | After persistent storage is configured, edit the ''/ | + | {{: |
- | ## These modules get modprobe' | + | {{: |
- | rtc | + | |
- | ## Comment out any modules you don't need. | + | |
- | ## | + | |
- | ## Ethernet support | + | |
- | ## Virtual first, then Emulated | + | |
- | ## | + | |
- | hv_netvsc | + | |
- | virtio-pci | + | |
- | vmxnet3 | + | |
- | pcnet32 | + | |
- | e1000 | + | |
- | e1000e | + | |
- | 8139too | + | |
- | Correspondingly, change | + | {{: |
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | Finally, configure AstLinux using the normal **[[userdoc: | ||
+ | |||
+ | !!Tip ->!! Note the "IPv4 Address:" |