userdoc:guest_vm_hyperv

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
userdoc:guest_vm_hyperv [2017/03/23 21:16]
abelbeck 		userdoc:guest_vm_hyperv [2017/03/24 16:38]
droemel
Line 4: Line 4:
  
 **VM Host Specifications:**  [[https://en.wikipedia.org/wiki/Hyper-V|Hyper-V]] **VM Host Specifications:**  [[https://en.wikipedia.org/wiki/Hyper-V|Hyper-V]]
 +
 +**VM Host Requirements:** Windows Server 2008 or newer, Windows 8 Professional or newer versions (64-bit)
  
 **AstLinux Board Type:** **AstLinux Board Type:**
Line 14: Line 16:
   * CPU: 2 Processor Cores   * CPU: 2 Processor Cores
   * Virtual Storage: 4 to 8 GB   * Virtual Storage: 4 to 8 GB
-  * Network: Bridged Interface+  * Network: Virtual Switch (needs to be created in advance in the Hyper-V Manager)
  
 **Configuration:** **Configuration:**
Line 24: Line 26:
 !!Tip ->!! Note the "IPv4 Address:" on the screen and access the VM with SSH or an HTTPS browser on the same network. !!Tip ->!! Note the "IPv4 Address:" on the screen and access the VM with SSH or an HTTPS browser on the same network.
  
-After persistent storage is configured, edit ''/etc/rc.modules'' file and uncomment ''hv_netvsc'' 
- 
-  ## These modules get modprobe'd when the system starts up. 
-  rtc 
-  ## Comment out any modules you don't need. 
-  ## 
-  ## Ethernet support 
-  ## Virtual first, then Emulated 
-  hv_netvsc 
-  virtio-pci 
-  vmxnet3 
-  pcnet32 
-  e1000 
-  e1000e 
-  8139too 
  • userdoc/guest_vm_hyperv.txt
  • Last modified: 2017/03/28 18:03
  • by abelbeck