Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:guest_vm_hyperv [2017/03/23 21:00] abelbeck created |
userdoc:guest_vm_hyperv [2017/03/24 12:02] droemel |
||
---|---|---|---|
Line 3: | Line 3: | ||
!!Note: AstLinux 1.2.10 or later is required!! | !!Note: AstLinux 1.2.10 or later is required!! | ||
- | **VM Host Specifications: | + | **VM Host Specifications: |
+ | |||
+ | **VM Host Requirements: | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 14: | Line 16: | ||
* CPU: 2 Processor Cores | * CPU: 2 Processor Cores | ||
* Virtual Storage: 4 to 8 GB | * Virtual Storage: 4 to 8 GB | ||
- | * Network: | + | * Network: |
+ | * !!Info:!! The Legacy Network Adapter uses the " | ||
**Configuration: | **Configuration: | ||
+ | ... TBD ... | ||
Finally, configure AstLinux using the normal **[[userdoc: | Finally, configure AstLinux using the normal **[[userdoc: | ||
!!Tip ->!! Note the "IPv4 Address:" | !!Tip ->!! Note the "IPv4 Address:" | ||
+ | |||
+ | After persistent storage is configured, edit the ''/ | ||
+ | |||
+ | ## These modules get modprobe' | ||
+ | rtc | ||
+ | ## Comment out any modules you don't need. | ||
+ | ## | ||
+ | ## Ethernet support | ||
+ | ## Virtual first, then Emulated | ||
+ | ## | ||
+ | hv_netvsc | ||
+ | virtio-pci | ||
+ | vmxnet3 | ||
+ | pcnet32 | ||
+ | e1000 | ||
+ | e1000e | ||
+ | 8139too | ||
+ | |||
+ | Correspondingly, |