Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
userdoc:board_qotom_q750g5 [2022/04/22 13:17] abelbeck |
userdoc:board_qotom_q750g5 [2022/04/22 14:04] abelbeck |
||
---|---|---|---|
Line 9: | Line 9: | ||
**Complete System Recommended Options:** | **Complete System Recommended Options:** | ||
- | * Memory: DDR4 2GB | + | * Memory: |
* Storage: mSATA SSD (PC Engines msata16 “Phison” or similar) | * Storage: mSATA SSD (PC Engines msata16 “Phison” or similar) | ||
Line 24: | Line 24: | ||
SENSEMODS=" | SENSEMODS=" | ||
+ | | ||
+ | ALERT_SOUNDS=" | ||
+ | ALERT_SOUNDS_OCTAVE=" | ||
| | ||
## Optional USB TTY serial login | ## Optional USB TTY serial login | ||
Line 70: | Line 73: | ||
**BIOS Setup for Boot OS Selection (UEFI):** | **BIOS Setup for Boot OS Selection (UEFI):** | ||
- | While in the BIOS Setup as above, to enable | + | !!UEFI Boot requires AstLinux 1.4.6 or later!! - additionally RUNNIX 0.6.10 or later is needed. |
+ | |||
+ | While in the BIOS Setup as above, to enable | ||
* '' | * '' | ||
- | !!Supported since AstLinux 1.4.6!! - additionally RUNNIX 0.6.10 or later is needed. | + | \\ |
**Other BIOS Settings** | **Other BIOS Settings** | ||
Line 83: | Line 87: | ||
If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the " | If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the " | ||
- | Or you can choose a temporary Boot-Device at the „Save & Exit“ tab under „Boot Override“ at the bottom (instead of a Boot-Menu). | + | Or you can choose a temporary Boot-Device at the "Save & Exit" |
**Photos:** | **Photos:** | ||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
\\ | \\ |