Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:board_qotom_q750g5 [2022/04/21 16:19] mkeuter |
userdoc:board_qotom_q750g5 [2022/04/22 13:48] abelbeck |
||
---|---|---|---|
Line 24: | Line 24: | ||
SENSEMODS=" | SENSEMODS=" | ||
+ | | ||
+ | ALERT_SOUNDS=" | ||
+ | ALERT_SOUNDS_OCTAVE=" | ||
| | ||
## Optional USB TTY serial login | ## Optional USB TTY serial login | ||
Line 48: | Line 51: | ||
The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the Qotom Q750G5 does not automatically power on after a power failure. | The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the Qotom Q750G5 does not automatically power on after a power failure. | ||
- | On startup (quickly) press the <DEL> key to enter the BIOS Setup, go to the " | + | On startup (quickly) press the <DEL> key to enter the BIOS Setup, go to the " |
- | * '' | + | * '' |
The results should like the following screen... | The results should like the following screen... | ||
- | {{: | + | {{: |
\\ | \\ | ||
**BIOS Setup for Boot OS Selection (non-UEFI): | **BIOS Setup for Boot OS Selection (non-UEFI): | ||
- | While in the BIOS Setup as above, | + | While in the BIOS Setup as above, to enable |
- | * '' | + | * '' |
The results should like the following screen... | The results should like the following screen... | ||
- | {{: | + | {{: |
+ | |||
+ | \\ | ||
+ | **BIOS Setup for Boot OS Selection (UEFI):** | ||
+ | |||
+ | !!UEFI Boot requires AstLinux 1.4.6 or later!! - additionally RUNNIX 0.6.10 or later is needed. | ||
+ | |||
+ | While in the BIOS Setup as above, to enable UEFI boot, go to the " | ||
+ | |||
+ | * '' | ||
+ | |||
+ | \\ | ||
+ | **Other BIOS Settings** | ||
+ | |||
+ | " | ||
Save the above BIOS changes, reboot. | Save the above BIOS changes, reboot. | ||
If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the " | If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the " | ||
- | Or you can choose a temporary Boot-Device at the „Save & Exit“ tab under „Boot Override“ at the bottom (instead of a Boot-Menu). | + | Or you can choose a temporary Boot-Device at the "Save & Exit" |
**Photos:** | **Photos:** | ||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
\\ | \\ |