Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:board_qotom_q190g4n-s07 [2017/04/25 12:38] abelbeck |
userdoc:board_qotom_q190g4n-s07 [2020/04/27 12:10] mkeuter |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Qotom Q190G4N-S07 Celeron J1900 Fanless Appliance ====== | ====== Qotom Q190G4N-S07 Celeron J1900 Fanless Appliance ====== | ||
- | !!Note: AstLinux 1.2.0 or later is required!! | + | !!Note: AstLinux 1.2.10 or later is required!! |
**Board Specifications: | **Board Specifications: | ||
+ | |||
+ | **Vendor:** [[http:// | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
- | * " | + | * " |
**Complete System Recommended Options:** | **Complete System Recommended Options:** | ||
Line 14: | Line 16: | ||
* Storage: mSATA SSD (PC Engines msata16 “Phison” or similar) | * Storage: mSATA SSD (PC Engines msata16 “Phison” or similar) | ||
- | **Total System Power (no VGA connection): | + | **Total System Power (no VGA connection): |
- | **Performance: | + | **Performance: |
- | | + | time ( echo " |
- | | + | |
**Configuration: | **Configuration: | ||
Line 29: | Line 30: | ||
| | ||
## Optional USB TTY serial login | ## Optional USB TTY serial login | ||
- | ## Requires AstLinux 1.2.10 or later | ||
USBTTY=" | USBTTY=" | ||
USBTTY_BAUD_RATE=" | USBTTY_BAUD_RATE=" | ||
+ | |||
+ | !!More Info ->!! | ||
+ | **[[userdoc: | ||
\\ | \\ | ||
Line 67: | Line 70: | ||
Save the above BIOS changes, reboot. | Save the above BIOS changes, reboot. | ||
+ | |||
+ | !!Note:!! On newer BIOS versions (12/2018) you might need to make the following changes, if you can't boot the AstLinux installation from an USB stick: | ||
+ | |||
+ | In " | ||
+ | |||
+ | * '' | ||
+ | * '' | ||
+ | |||
+ | If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the " | ||
+ | Or you can choose a temporary Boot-Device at the „Save & Exit“ tab under „Boot Override“ at the bottom (instead of Boot-Menu). | ||
**Photos:** | **Photos:** |