Differences

This shows you the differences between two versions of the page.

--- userdoc:board_pcengines_apu2 [2017/04/20 21:46] – abelbeck
+++ userdoc:board_pcengines_apu2 [2023/05/13 16:13] (current) – mkeuter
@@ Line 5: / Line 5: @@
 !!Note: PC Engines apu2_160307 BIOS is fully functional, though missing ECC support and performance tweaks!!
-**Board Specifications:**  [[http://pcengines.ch/apu2c4.htm|apu2c]]
+!!Note: For new installations: the PC Engines APU platform will be soon EOL :-(!!
+EOL[[https://pcengines.ch/eol.htm|Announcement]]
+**Board Specifications:**  [[https://pcengines.ch/apu2.htm|apu2c]]
 **AstLinux Board Type:**
-  * "genx86_64-serial" (19200 / 115200 baud serial console)
+  * "genx86_64-serial" (Serial Console: ''19200'' baud for AstLinux 1.2.10 and earlier, ''115200'' baud for AstLinux 1.3.0 and later)
 **Complete System Recommended Options:**
@@ Line 24: / Line 28: @@
 **Total System Power:**  6 Watts when idle.
-**Performance:**  77.3 secs. (Maximum OpenVPN: 77 Mbps)
+**Performance:**  66.6 secs. (Single-core test, lower is better)
-  openvpn --genkey --secret /tmp/secret
+  time ( echo "scale=3456; 4*a(1)" | bc -l )
-  time openvpn --test-crypto --secret /tmp/secret --verb 0 --tun-mtu 20000 --cipher aes-256-cbc
 **Configuration:**
@@ Line 46: / Line 49: @@
   # k10temp CPU sensor
+  chip "k10temp-pci-00c3"
+  label temp1 "CPU Temp"
 \\
 **Serial Console COM Port:**
-The board type of "genx86_64-serial" defaults to a 19200 baud serial console, unfortunately the PC Engines's BIOS is fixed at 115200 baud, so if you want to view the BIOS console you must change the AstLinux serial console speed to match at 115200 baud.  After
+!!Note ->!! Skip this section for AstLinux 1.3.0 and later, which uses a ''115200'' baud rate.
+For AstLinux 1.2.10 and earlier, the board type of "genx86_64-serial" defaults to a 19200 baud serial console, unfortunately the PC Engines's BIOS is fixed at 115200 baud, so if you want to view the BIOS console you must change the AstLinux serial console speed to match at 115200 baud.  After
 **[[userdoc:new-install#persistent_storage_options_gui|persistent storage]]**
 has been configured, from the CLI issue the following command:
@@ Line 58: / Line 66: @@
 !!Tip ->!! A reboot is required for the change to take effect.
+!!Note:!! Wake-on-LAN (WOL) does __only__ work on eth2 (next to the USB ports)!