Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
userdoc:board_pcengines_apu2 [2016/04/10 11:21] abelbeck created |
userdoc:board_pcengines_apu2 [2023/05/13 11:13] (current) mkeuter |
||
---|---|---|---|
Line 3: | Line 3: | ||
!!Note: AstLinux 1.2.7 or later is required!! | !!Note: AstLinux 1.2.7 or later is required!! | ||
- | !!Note: PC Engines | + | !!Note: PC Engines |
- | **Board Specifications: | + | !!Note: For new installations: |
+ | |||
+ | EOL[[https:// | ||
+ | |||
+ | **Board Specifications: | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
- | * " | + | * " |
**Complete System Recommended Options:** | **Complete System Recommended Options:** | ||
Line 16: | Line 20: | ||
* Case: case1d2blku / case1d2redu or equivalent. | * Case: case1d2blku / case1d2redu or equivalent. | ||
* AC Power Adapter (12 VDC, 2A, inner diameter 2.5 mm, outer 5.5 mm, center positive, it differs from the Alix) | * AC Power Adapter (12 VDC, 2A, inner diameter 2.5 mm, outer 5.5 mm, center positive, it differs from the Alix) | ||
- | * Storage: mSATA SSD | + | * Storage: mSATA SSD (PC Engines msata16d " |
* Included: | * Included: | ||
* 2GB (apu2c2) or 4GB (apu2c4) DRAM | * 2GB (apu2c2) or 4GB (apu2c4) DRAM | ||
+ | * Optional: | ||
+ | * Power Button - Logic Supply [[https:// | ||
**Total System Power: | **Total System Power: | ||
+ | |||
+ | **Performance: | ||
+ | |||
+ | time ( echo " | ||
**Configuration: | **Configuration: | ||
Line 39: | Line 49: | ||
| | ||
# k10temp CPU sensor | # k10temp CPU sensor | ||
+ | chip " | ||
+ | | ||
+ | label temp1 "CPU Temp" | ||
\\ | \\ | ||
**Serial Console COM Port:** | **Serial Console COM Port:** | ||
- | The board type of "geni586-serial" | + | !!Note ->!! Skip this section for AstLinux 1.3.0 and later, which uses a '' |
+ | |||
+ | For AstLinux 1.2.10 and earlier, the board type of "genx86_64-serial" | ||
**[[userdoc: | **[[userdoc: | ||
has been configured, from the CLI issue the following command: | has been configured, from the CLI issue the following command: | ||
Line 51: | Line 66: | ||
!!Tip ->!! A reboot is required for the change to take effect. | !!Tip ->!! A reboot is required for the change to take effect. | ||
+ | |||
+ | !!Note:!! Wake-on-LAN (WOL) does __only__ work on eth2 (next to the USB ports)! | ||
Line 62: | Line 79: | ||
{{: | {{: | ||
- |