Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:board_pcengines_apu2 [2016/06/06 14:55] abelbeck |
userdoc:board_pcengines_apu2 [2019/05/30 17:45] abelbeck |
||
---|---|---|---|
Line 9: | Line 9: | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
- | * " | + | * " |
**Complete System Recommended Options:** | **Complete System Recommended Options:** | ||
Line 24: | Line 24: | ||
**Total System Power: | **Total System Power: | ||
- | **Performance: | + | **Performance: |
openvpn --genkey --secret /tmp/secret | openvpn --genkey --secret /tmp/secret | ||
Line 46: | Line 46: | ||
| | ||
# k10temp CPU sensor | # k10temp CPU sensor | ||
+ | chip " | ||
+ | | ||
+ | label temp1 "CPU Temp" | ||
\\ | \\ | ||
**Serial Console COM Port:** | **Serial Console COM Port:** | ||
- | The board type of "geni586-serial" | + | !!Note ->!! Skip this section for AstLinux 1.3.0 and later, which uses a '' |
+ | |||
+ | For AstLinux 1.2.10 and earlier, the board type of "genx86_64-serial" | ||
**[[userdoc: | **[[userdoc: | ||
has been configured, from the CLI issue the following command: | has been configured, from the CLI issue the following command: | ||
Line 58: | Line 63: | ||
!!Tip ->!! A reboot is required for the change to take effect. | !!Tip ->!! A reboot is required for the change to take effect. | ||
+ | |||
+ | !!Note:!! Wake-on-LAN (WOL) does __only__ work on eth2 (next to the USB ports)! | ||