userdoc:board_oem_2550l2d-mxpc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
userdoc:board_oem_2550l2d-mxpc [2014/05/06 19:39]
abelbeck
userdoc:board_oem_2550l2d-mxpc [2019/07/24 23:05] (current)
abelbeck
Line 10: Line 10:
 **AstLinux Board Type:** **AstLinux Board Type:**
  
-  * "geni586" (VGA video console)+  * "genx86_64" (Video Console: VGA
 +  * "genx86_64-serial" (Serial Console with optional cable)
  
 **Complete System Recommended Options:** **Complete System Recommended Options:**
Line 23: Line 24:
       * SATA data/power cables and tray for 2.5" SSD (remove if not being used)       * SATA data/power cables and tray for 2.5" SSD (remove if not being used)
   * Optional:   * Optional:
 +      * Serial Console Cable, IDC10 to DB9, AT/Everex pinout (photo below)
       * Internal Speaker with 4-pin connector for ALERT_SOUNDS (photo below)       * Internal Speaker with 4-pin connector for ALERT_SOUNDS (photo below)
  
 **Total System Power:**  13 Watts when idle. **Total System Power:**  13 Watts when idle.
 +
 +**Performance:**  47.6 secs. (Single-core test, lower is better)
 +
 +  time ( echo "scale=3456; 4*a(1)" | bc -l )
  
 **Configuration:** **Configuration:**
Line 53: Line 59:
      
   ignore cpu0_vid   ignore cpu0_vid
 +  ignore intrusion0
   ignore temp2   ignore temp2
   ignore temp3   ignore temp3
Line 94: Line 101:
  
 \\ \\
-**BIOS Setup for Auto-Power-On after Power Failure:**+**BIOS Setup for LAN BootROM and Auto-Power-On after Power Failure:**
  
-On startup press the <DEL> key to enter the BIOS Setup, go to "Advanced" -> "Power Management Configuration" .  Make the following change...+On startup press the <DEL> key to enter the BIOS Setup... 
 + 
 +Go to "Advanced" -> "Onboard Device Configuration"select and set: 
 + 
 +  * ''Onboard Lan BootROM Control -> Disabled'' 
 + 
 +Go to "Advanced" -> "Power Management Configuration", select and set:
  
   * ''Restore AC Power Loss -> Power On''   * ''Restore AC Power Loss -> Power On''
  
 +Save the above BIOS changes, reboot.
  
 **Photos:** **Photos:**
Line 119: Line 133:
 \\ \\
 {{:userdoc:oem_2550L2D-MxPC-speaker.jpg?nolink|Optional Speaker}} {{:userdoc:oem_2550L2D-MxPC-speaker.jpg?nolink|Optional Speaker}}
- 
- 
- 
  • userdoc/board_oem_2550l2d-mxpc.1399423183.txt.gz
  • Last modified: 2014/05/06 19:39
  • by abelbeck