Differences

This shows you the differences between two versions of the page.

--- userdoc:board_oem_2550l2d-mxpc [2014/05/06 19:39]
abelbeck
+++ userdoc:board_oem_2550l2d-mxpc [2019/07/24 21:30]
abelbeck
@@ Line 10: / Line 10: @@
 **AstLinux Board Type:**
-  * "geni586" (VGA video console)
+  * "genx86_64" (Video Console: VGA)
+  * "genx86_64-serial" (Serial Console with optional cable)
 **Complete System Recommended Options:**
@@ Line 23: / Line 24: @@
       * SATA data/power cables and tray for 2.5" SSD (remove if not being used)
   * Optional:
+      * Serial Console Cable, IDC10 to DB9, AT/Everex pinout (photo below)
       * Internal Speaker with 4-pin connector for ALERT_SOUNDS (photo below)
 **Total System Power:**  13 Watts when idle.
+**Performance:**  ??.? secs. (Single-core test, lower is better)
+  time ( echo "scale=3456; 4*a(1)" | bc -l )
 **Configuration:**
@@ Line 53: / Line 59: @@
   ignore cpu0_vid
+  ignore intrusion0
   ignore temp2
   ignore temp3
@@ Line 94: / Line 101: @@
 \\
-**BIOS Setup for Auto-Power-On after Power Failure:**
+**BIOS Setup for LAN BootROM and Auto-Power-On after Power Failure:**
-On startup press the <DEL> key to enter the BIOS Setup, go to "Advanced" -> "Power Management Configuration" .  Make the following change...
+On startup press the <DEL> key to enter the BIOS Setup...
+Go to "Advanced" -> "Onboard Device Configuration", select and set:
+  * ''Onboard Lan BootROM Control -> Disabled''
+Go to "Advanced" -> "Power Management Configuration", select and set:
   * ''Restore AC Power Loss -> Power On''
+Save the above BIOS changes, reboot.
 **Photos:**
@@ Line 119: / Line 133: @@
 \\
 {{:userdoc:oem_2550L2D-MxPC-speaker.jpg?nolink|Optional Speaker}}