userdoc:board_jetway_nf9hql-525

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
userdoc:board_jetway_nf9hql-525 [2017/06/11 08:48]
abelbeck 		userdoc:board_jetway_nf9hql-525 [2017/06/11 09:15]
abelbeck
Line 93: Line 93:
  
 First, configure your serial terminal program to support ANSI color and 115200 baud.  If you are using minicom be sure to add the ' ''-c on'' ' option to the minicom command line, otherwise the ANSI colors will not be distinguishable in the BIOS Setup screen. First, configure your serial terminal program to support ANSI color and 115200 baud.  If you are using minicom be sure to add the ' ''-c on'' ' option to the minicom command line, otherwise the ANSI colors will not be distinguishable in the BIOS Setup screen.
 +
 +!!Note ->!! Leave ''Serial Port Mode -> 115200 8,n,1'' for AstLinux 1.3.0 and later.
  
 Second, on startup type F4 (<ESC>OS) to enter the BIOS Setup, go to the "Integrated Peripherals" -> "Remote Access Configuration" .  Make the following changes... Second, on startup type F4 (<ESC>OS) to enter the BIOS Setup, go to the "Integrated Peripherals" -> "Remote Access Configuration" .  Make the following changes...
Line 110: Line 112:
 The above example slows the CPU fan for normal operation and reduces the noise. The above example slows the CPU fan for normal operation and reduces the noise.
  
-Finally, save the above BIOS changes, reboot, and reconfigure you serial terminal program to 19200 baud, this will match what AstLinux expects.+Finally, save the above BIOS changes, reboot, and reconfigure you serial terminal program if you changed the baud rate.
  
 **Photos:** **Photos:**
  • userdoc/board_jetway_nf9hql-525.txt
  • Last modified: 2019/07/24 22:36
  • by abelbeck