userdoc:board_jetway_jbc373f38w

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
userdoc:board_jetway_jbc373f38w [2013/05/01 23:32]
abelbeck
userdoc:board_jetway_jbc373f38w [2019/07/24 22:43] (current)
abelbeck
Line 2: Line 2:
  
 !!Note: Requires AstLinux 1.x!! !!Note: Requires AstLinux 1.x!!
 +
 +!!Note:!! **Not Recommended!**  This appliance has been failing (multiple reports) after 3-5 years of use, presumably heat related.
  
 This barebone appliance is also known by the Jetway Part No: HBJC373F38 / HBJC373F38W This barebone appliance is also known by the Jetway Part No: HBJC373F38 / HBJC373F38W
Line 9: Line 11:
 **AstLinux Board Type:** **AstLinux Board Type:**
  
-  * "geni586" (VGA video console+  * "genx86_64" (Video Console: VGA) 
-  * "geni586-serial" (19200 baud serial console)+  * "genx86_64-serial" (Serial Console: ''19200'' baud for AstLinux 1.2.10 and earlier, ''115200'' baud for AstLinux 1.3.0 and later)
  
 **Complete System Recommended Options:** **Complete System Recommended Options:**
Line 26: Line 28:
  
 **Total System Power:**  15 Watts when idle. **Total System Power:**  15 Watts when idle.
 +
 +**Performance:**  ~50 secs. (Single-core test, lower is better)
 +
 +  time ( echo "scale=3456; 4*a(1)" | bc -l )
  
 **Configuration:** **Configuration:**
Line 83: Line 89:
 **Serial Console COM Port:** **Serial Console COM Port:**
  
-If the board type of "geni586-serial" is used, you can change the serial console from the default, rear COM port to the front panel COM port.  From the CLI issue the following command:+If the board type of "genx86_64-serial" is used, you can change the serial console from the default, rear COM port to the front panel COM port.  From the CLI issue the following command:
  
-  setconsole-speed-tty 19200 ttyS1+  setconsole-speed-tty 115200 ttyS1
  
 Revert back to the default rear COM port with the command: Revert back to the default rear COM port with the command:
Line 120: Line 126:
  
 \\  \\ 
- 
  • userdoc/board_jetway_jbc373f38w.1367469149.txt.gz
  • Last modified: 2013/05/01 23:32
  • by abelbeck