Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
userdoc:board_hpe_microserver_x3421 [2019/06/03 14:54] abelbeck |
userdoc:board_hpe_microserver_x3421 [2019/07/24 21:12] (current) abelbeck |
||
---|---|---|---|
Line 22: | Line 22: | ||
**Total System Power: | **Total System Power: | ||
- | **Performance: | + | **Performance: |
- | | + | time ( echo " |
- | | + | |
**Configuration: | **Configuration: | ||
Line 47: | Line 46: | ||
\\ | \\ | ||
- | **BIOS NIC Setup for Ethernet PXE Boot:** | + | **BIOS NIC Setup for Ethernet PXE Boot (disable):** |
On startup press the '' | On startup press the '' | ||
Line 54: | Line 53: | ||
* '' | * '' | ||
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
Line 67: | Line 66: | ||
* '' | * '' | ||
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
Line 74: | Line 73: | ||
**BIOS Setup for Boot Mode (non-UEFI): | **BIOS Setup for Boot Mode (non-UEFI): | ||
- | While in the BIOS Setup as above, | + | While in the BIOS Setup as above, make certain |
* '' | * '' | ||
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
Line 86: | Line 85: | ||
!!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the '' | !!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the '' | ||
+ | |||
+ | !!Note ->!! The final HPE boot screen with the QR code displayed appears for 40 seconds, there does not appear to be a way to shorten this boot delay. | ||
**Photos:** | **Photos:** |