Differences

This shows you the differences between two versions of the page.

--- userdoc:board_hpe_microserver_x3421 [2019/06/03 20:02] – abelbeck
+++ userdoc:board_hpe_microserver_x3421 [2019/07/25 02:12] (current) – abelbeck
@@ Line 22: / Line 22: @@
 **Total System Power:**  16 Watts when idle.
-**Performance:**  25.7 secs. (Single-core test, lower is better)
+**Performance:**  28.0 secs. (Single-core test, lower is better)
-  openvpn --genkey --secret /tmp/secret
+  time ( echo "scale=3456; 4*a(1)" | bc -l )
-  time openvpn --test-crypto --secret /tmp/secret --verb 0 --tun-mtu 20000 --cipher aes-256-cbc
 **Configuration:**
@@ Line 47: / Line 46: @@
 \\
-**BIOS NIC Setup for Ethernet PXE Boot:**
+**BIOS NIC Setup for Ethernet PXE Boot (disable):**
 On startup press the ''Control-S'' key to enter the BIOS NIC Setup, For each of the two NIC's, make the following changes...
@@ Line 54: / Line 53: @@
   * ''Banner Message Timeout -> 2 Seconds''
-The results should like the following screen...
+The results should look like the following screen...
 {{:userdoc:hpe-microserver-x3421-bios-nic-pxe.png?nolink|BIOS NIC PXE}}
@@ Line 67: / Line 66: @@
   * ''Restore On Power Loss -> Power On''
-The results should like the following screen...
+The results should look like the following screen...
 {{:userdoc:hpe-microserver-x3421-bios-power-on.png?nolink|BIOS Power On}}
@@ Line 78: / Line 77: @@
   * ''Boot Mode -> Legacy only''
-The results should like the following screen...
+The results should look like the following screen...
 {{:userdoc:hpe-microserver-x3421-bios-legacy-boot.png?nolink|BIOS Legacy Boot}}
@@ Line 87: / Line 86: @@
 !!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the ''F11'' key.
-!!Note ->!! The final HPE boot screen with the QR code displayed appears to 40 seconds, there does not appear to be a way to shorten this boot delay.
+!!Note ->!! The final HPE boot screen with the QR code displayed appears for 40 seconds, there does not appear to be a way to shorten this boot delay.
 **Photos:**