Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
userdoc:board_hpe_microserver_x3421 [2019/06/02 17:53] abelbeck |
userdoc:board_hpe_microserver_x3421 [2019/06/03 15:14] abelbeck |
||
---|---|---|---|
Line 8: | Line 8: | ||
[[https:// | [[https:// | ||
- | !!Note ->!! The description below applies to running AstLinux "bare metal" | + | !!Note ->!! The description below applies to running AstLinux "bare metal" |
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 47: | Line 47: | ||
\\ | \\ | ||
- | **BIOS NIC Setup for Ethernet PXE Boot:** | + | **BIOS NIC Setup for Ethernet PXE Boot (disable):** |
- | On startup press the '' | + | On startup press the '' |
- | The results should like the following screen... | + | * '' |
+ | * '' | ||
+ | |||
+ | The results should | ||
{{: | {{: | ||
Line 60: | Line 63: | ||
The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | ||
- | On startup press the '' | + | On startup press the '' |
* '' | * '' | ||
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
\\ | \\ | ||
- | **BIOS Setup for Boot Option Filter | + | **BIOS Setup for Boot Mode (non-UEFI): |
- | While in the BIOS Setup as above, | + | While in the BIOS Setup as above, make certain |
- | * '' | + | * '' |
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
Line 83: | Line 86: | ||
!!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the '' | !!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the '' | ||
+ | |||
+ | !!Note ->!! The final HPE boot screen with the QR code displayed appears for 40 seconds, there does not appear to be a way to shorten this boot delay. | ||
**Photos:** | **Photos:** |