Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
userdoc:board_hpe_microserver_x3421 [2019/06/02 11:16] abelbeck |
userdoc:board_hpe_microserver_x3421 [2019/07/24 21:12] abelbeck |
||
---|---|---|---|
Line 7: | Line 7: | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
+ | !!Note ->!! The description below applies to running AstLinux "bare metal" | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 20: | Line 22: | ||
**Total System Power: | **Total System Power: | ||
- | **Performance: | + | **Performance: |
- | | + | time ( echo " |
- | | + | |
**Configuration: | **Configuration: | ||
Line 45: | Line 46: | ||
\\ | \\ | ||
- | **NIC BIOS Setup for Ethernet PXE Boot:** | + | **BIOS |
- | On startup press the '' | + | On startup press the '' |
+ | |||
+ | * '' | ||
+ | * '' | ||
+ | |||
+ | The results should look like the following screen... | ||
+ | |||
+ | {{: | ||
\\ | \\ | ||
Line 54: | Line 62: | ||
The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | ||
- | On startup press the '' | + | On startup press the '' |
* '' | * '' | ||
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
\\ | \\ | ||
- | **BIOS Setup for Boot Option Filter | + | **BIOS Setup for Boot Mode (non-UEFI): |
- | While in the BIOS Setup as above, | + | While in the BIOS Setup as above, make certain |
- | * '' | + | * '' |
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
Line 77: | Line 85: | ||
!!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the '' | !!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the '' | ||
+ | |||
+ | !!Note ->!! The final HPE boot screen with the QR code displayed appears for 40 seconds, there does not appear to be a way to shorten this boot delay. | ||
**Photos:** | **Photos:** |