Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
userdoc:board_hpe_microserver_x3421 [2019/06/02 11:09] abelbeck |
userdoc:board_hpe_microserver_x3421 [2019/06/03 15:14] abelbeck |
||
---|---|---|---|
Line 7: | Line 7: | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
+ | !!Note ->!! The description below applies to running AstLinux "bare metal" | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 43: | Line 45: | ||
| | ||
label temp1 "CPU Temp" | label temp1 "CPU Temp" | ||
+ | |||
+ | \\ | ||
+ | **BIOS NIC Setup for Ethernet PXE Boot (disable): | ||
+ | |||
+ | On startup press the '' | ||
+ | |||
+ | * '' | ||
+ | * '' | ||
+ | |||
+ | The results should look like the following screen... | ||
+ | |||
+ | {{: | ||
\\ | \\ | ||
Line 49: | Line 63: | ||
The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | ||
- | On startup | + | On startup press the '' |
* '' | * '' | ||
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
\\ | \\ | ||
- | **BIOS Setup for Boot Option Filter | + | **BIOS Setup for Boot Mode (non-UEFI): |
- | While in the BIOS Setup as above, | + | While in the BIOS Setup as above, make certain |
- | * '' | + | * '' |
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
Line 71: | Line 85: | ||
Save the above BIOS changes, reboot. | Save the above BIOS changes, reboot. | ||
- | !!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup | + | !!Tip ->!! If you need to choose the boot drive, for example when booting the ISO Installer via a USB drive, on startup press the '' |
+ | |||
+ | !!Note ->!! The final HPE boot screen with the QR code displayed appears for 40 seconds, there does not appear to be a way to shorten this boot delay. | ||
**Photos:** | **Photos:** |