Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:board_hpe_microserver_x3421 [2019/06/02 11:15] abelbeck |
userdoc:board_hpe_microserver_x3421 [2019/06/03 14:54] abelbeck |
||
---|---|---|---|
Line 7: | Line 7: | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
+ | !!Note ->!! The description below applies to running AstLinux "bare metal" | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 45: | Line 47: | ||
\\ | \\ | ||
- | **NIC Setup for Ethernet PXE Boot:** | + | **BIOS NIC Setup for Ethernet PXE Boot:** |
+ | |||
+ | On startup press the '' | ||
+ | |||
+ | * '' | ||
+ | * '' | ||
+ | |||
+ | The results should like the following screen... | ||
- | On startup press the '' | + | {{: |
\\ | \\ | ||
Line 54: | Line 63: | ||
The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the HPE MicroServer does not automatically power on after a power failure. | ||
- | On startup press the '' | + | On startup press the '' |
* '' | * '' | ||
Line 63: | Line 72: | ||
\\ | \\ | ||
- | **BIOS Setup for Boot Option Filter | + | **BIOS Setup for Boot Mode (non-UEFI): |
- | While in the BIOS Setup as above, check to make sure Legacy only boot is enabled, go to the " | + | While in the BIOS Setup as above, check to make sure Legacy only boot is enabled, go to the " |
- | * '' | + | * '' |
The results should like the following screen... | The results should like the following screen... |