Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
userdoc:board_bmax_b1_plus [2023/02/25 09:18] abelbeck |
userdoc:board_bmax_b1_plus [2023/11/06 15:16] abelbeck |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Bmax B1 Plus Celeron N3350 Fanless Mini PC ====== | + | ====== Bmax B1 Plus/Pro Celeron N3350/ |
!!Note: AstLinux 1.5.0 or later is recommended!! | !!Note: AstLinux 1.5.0 or later is recommended!! | ||
**Board Specifications: | **Board Specifications: | ||
+ | |||
+ | The Bmax B1 Plus/Pro Mini PC currently (November 2023) can be purchased new for ~$100 USD. The value proposition is key, running AstLinux quite nicely, albeit with a single ethernet interface. Alternatively, | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 15: | Line 17: | ||
**Total System Power (no VGA/HDMI connection): | **Total System Power (no VGA/HDMI connection): | ||
- | **Performance: | + | **Performance |
+ | **Performance (B1 Pro): | ||
time ( echo " | time ( echo " | ||
Line 37: | Line 40: | ||
# libsensors configuration file | # libsensors configuration file | ||
# ----------------------------- | # ----------------------------- | ||
- | # Bmax B1 Plus | + | # Bmax B1 Plus/Pro |
| | ||
# coretemp CPU sensor | # coretemp CPU sensor | ||
Line 48: | Line 51: | ||
* '' | * '' | ||
* '' | * '' | ||
- | * '' | + | * '' |
- | * '' | + | * '' |
* '' | * '' | ||
!!Important ->!! Disabling eMMC support will prevent booting to Windows. | !!Important ->!! Disabling eMMC support will prevent booting to Windows. | ||
- | The results should like the following screen... | + | The results should |
{{: | {{: | ||
Line 71: | Line 74: | ||
Save the above BIOS changes, reboot. | Save the above BIOS changes, reboot. | ||
- | Optional, choose whether UEFI or Legacy boot is enabled (example: UEFI only), go to the " | + | Optional, with '' |
* '' | * '' | ||
- | The results would like the following screen... | + | The results would look like the following screen... |
{{: | {{: | ||
Line 86: | Line 89: | ||
!!Requires AstLinux 1.5.0 or later!! | !!Requires AstLinux 1.5.0 or later!! | ||
- | Using the CLI, then enter: | + | Using the CLI, enter the command: |
set-kcmd-cstate help | set-kcmd-cstate help |