devdoc:devdoc_create_image

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
devdoc:devdoc_create_image [2012/03/01 10:43]
abelbeck
devdoc:devdoc_create_image [2022/05/21 10:53] (current)
mkeuter
Line 6: Line 6:
   ./scripts/astlinux-makeimage -z 256 256 0   ./scripts/astlinux-makeimage -z 256 256 0
  
-This creates an astlinux-xxx.img.gz file with a single FAT16 partition of 192MB.+This creates an astlinux-xxx.img.gz file with a single FAT16 partition of 256MB.
  
 Burn this image to a CF or USB flash drive: Burn this image to a CF or USB flash drive:
Line 12: Line 12:
   zcat astlinux-xxx.img.gz | dd of=/dev/sdc bs=64k   zcat astlinux-xxx.img.gz | dd of=/dev/sdc bs=64k
  
-(if ''/dev/sdc'' is where my system detects the CF... Be very careful to get of= correct...)+(if ''/dev/sdc'' is where my system detects the CF... Be very careful to get ''of='' correct...)
  
 If you hadn't used the -z flag, then it would just be: If you hadn't used the -z flag, then it would just be:
Line 24: Line 24:
   sync   sync
  
-At this point, you may remove your CF and install it into your target system, power up... boot, and follow http://doc.astlinux.org/userdoc:new-install to complete the process.+At this point, you may remove your CF and install it into your target system, power up... boot,\\ and follow **[[userdoc:new-install|New Installation]]** to complete the process.
  
 +\\ 
 +
 +\\ 
 +
 +!!Note:!! The above ''./scripts/astlinux-makeimage'' part does NOT work in a virtual machine, which runs as an LXC container (e.g. in Proxmox). You'll need a "real" VM (with full Hardware-Virtualization) for this to work.
  • devdoc/devdoc_create_image.1330620205.txt.gz
  • Last modified: 2012/03/01 10:43
  • (external edit)