Differences

This shows you the differences between two versions of the page.

--- devdoc:devdoc_create_image [2011/11/20 09:49]
abelbeck
+++ devdoc:devdoc_create_image [2022/05/21 10:53] (current)
mkeuter
@@ Line 4: / Line 4: @@
 After running ''./scripts/build'', do:
-  ./scripts/astlinux-makeimage -z 192 192 0
+  ./scripts/astlinux-makeimage -z 256 256 0
-This creates an astlinux-xxx.img.gz file with a single FAT16 partition of 192MB.
+This creates an astlinux-xxx.img.gz file with a single FAT16 partition of 256MB.
 Burn this image to a CF or USB flash drive:
@@ Line 12: / Line 12: @@
   zcat astlinux-xxx.img.gz | dd of=/dev/sdc bs=64k
-(if ''/dev/sdc'' is where my system detects the CF... Be very careful to get of= correct...)
+(if ''/dev/sdc'' is where my system detects the CF... Be very careful to get ''of='' correct...)
 If you hadn't used the -z flag, then it would just be:
@@ Line 24: / Line 24: @@
   sync
-At this point, you may remove your CF and install it into your target system, power up... boot, and follow http://doc.astlinux.org/userdoc:new-install to complete the process.
+At this point, you may remove your CF and install it into your target system, power up... boot,\\ and follow **[[userdoc:new-install|New Installation]]** to complete the process.
+\\
+\\
+!!Note:!! The above ''./scripts/astlinux-makeimage'' part does NOT work in a virtual machine, which runs as an LXC container (e.g. in Proxmox). You'll need a "real" VM (with full Hardware-Virtualization) for this to work.